I marked the stripes with a ruler and a white pencil.I used an oversized felt in the toe area so I could secure the fabric to the bottom.To make red shoes, I applied the red felt fabric to an old pair of shoes with a foam brush and sticky glue. I spray-Apply the blade to gold and require 4 coats to fully cover all silver plastic.I used 52 stripes in total.I use embroidery thread and embroidery needle.Because the dress was made for my brother, I used him as a model and put a few pieces of scrap cloth on him with a pin to make the shape of the jacket.The plastic handle of the sword is too wide to fit into the coconut, so I started fixing the sword on a pair with a saw and cutting off the excess plastic.Supply: Plastic Sword, Gold painting, coconut, faux leather, paint, paint brush, felt, foam, electrical tape, handsaw, awl and knife.
Then straighten the hair with a comb.I poked a hole in the felt where my shoelaces slipped.I finished with faux leather and hand stitched closed handles.Then comb the hair and the shape is good.The next step is to prepare the wig for the hair color.Here you will find all the steps to make this outfit and I hope you like it!Supply: Black artificial leather, black canvas fabric, fusible interface, red fabric, black thread, black embroidery thread, sewing machine, wood beads, embroidery needle, scissors, iron, drill pin, colored pencil and paper.I created 3 wide Mohawk, each with a thin hair.While waiting for the sword to dry, I started working on the coconut handle.Once I chose half of what I was going to use as a handle, I removed the coconut meat.I found it easiest to cut a small piece at a time with a knife.I use the blunt side of the knife to tap steadily in the middle of the coconut until it is completely separated.I added bronze paint on the bone beads to keep the old look.I wrap the bottom of the blade with a thin layer of felt so that it can go through the slit tightly.
I sew each edge on the shoulder seam, alternating the color.When both the sword and the coconut are completely dry, I insert the sword into the coconut.I used the seams of my shoes as a guide to cutting each piece of fabric, leaving something extra that I could trim later on.
https://www.embroiderymachinery.net/product/single-double-head-series/