Make sure that one end of each wire has at least 30mm clean stripped, and the other side of each wire about 100mm clean stripped. When it starts to rain, the buzzer will go off and warn you that your clothes or curtains might get wet!
https://www.szzzxcl.com/
The power or &lightning rod39;electrical energy&Copper Clad Steel Manufacturers39; stored in a battery can only be released and allowed to flow when a complete circuit is made out of wires or other 'conductors' that conduct electricity. Place the clothespin and tablet configuration on the sill of your window (you can use rubber cement to hold it in position). Don't you think it will be useful to have an early warning system for rain to warn you to close the windows and bring in the clothes from the clothesline? In the following science experiment you will build a device that can detect rain as soon as the first drops start to fall:

WHAT YOU NEED:

9 Volt battery Plastic coated copper wire 9 Volt buzzer or bell Clothespin Effervescent tables Wire cutters Rubber cement
HOW TO PROCEED:

Cut two pieces of thin plastic coated wire of about 2m - 3m each (or long enough to reach from the outside of your window to the inside of your bedroom where the buzzer # and battery will be positioned). When the circuit is complete and # the current is flowing, the buzzer sounds to warn you of the rain that started to fall!

Article by J Botes, of www. Reproductions of this article are allowed but must include a link pointing to www. The current flows in a complete 'loop' from the battery through the 'rain detector' on the window sill to the buzzer and battery in your room. Place a small effervescent-type of tablet in between the two prongs with the contact pieces of the clothespin to prevent them from touching.experiland.com. Push the 100mm stripped clean ends of both wires through a small opening in your bedroom window, and connects the other ends to the terminals of a 9-V battery, and an electrical buzzer or a bell. You may need to experiment with several types of tables to find the most suitable one, which degenerate the fastest when coming in contact with water or 'rain'.
Many electrical devices are used as early warning systems such as burglar alarms, electric fencing systems and many more. On the outside of your window, connect a wooden or plastic clothespin to the other ends of the wires by winding it several times over each of the front ends of the clothespin.experiland. Use wire cutters to strip clean the ends of both wires. Use another shorter piece of wire to connect the battery and the bell to each other as in the diagram above. This will be your two contact pieces to complete the electrical circuit. In the above experiment, the electrical circuit is not complete until the prongs of the clothes pins with the wires wrapped around it are pressed together.com, a website dedicated to provide elementary and middle school children with science education in the form of fun, tried and tested science experiment ideas in five main categories. When the rain drops degenerate and melt the effervescent tablet, the prongs with the wire contact pieces are pressed together, making a circular path between the battery and the bell