And caulk that is too hot might become fluid or runny, which means it won't leave a smooth bead - a must for a professional finish. The most important step in achieving a professional-looking and Round Kraft Tube Box suppliersseamless caulking job is tooling. Once the surface is dry, it's time to begin. End the bead quickly so the excess product doesn't build up at the end of your bead. Caulk that's too cold will be too stiff to flow smoothly out of the tube. When tooling the caulk, be careful to avoid excess tooling - scrape away too much of the caulk and you starve the joint of sealant (and waste a lot of caulk). It's also easier to cut more off of the tip than it is to try and work with a tip that's too large. It's very important, especially with silicone, to allow the caulk to adjust to room temperature before applying it. Before you apply the caulk, use denatured alcohol to wipe away any grim, grease or dirt that could affect the way the caulk bonds with the surface. You simply spray it onto the bead of the caulk and paper tube packaging manufacturers tool it with your finger. Once the caulk is acclimated, you need to cut the tip of the caulk tube. You will find that a smaller opening helps keep you from overfilling the joint. The first step is to acclimate the caulk.Copyright (c) 2010 Ron Hazelton If you've ever tried caulking a kitchen sink or bathtub, you might have been frustrated with the mess or disappointed in the unprofessional result. But with a few tips, some practice and a handy product like Caulk Mate, you can easily achieve a seamless, professional-looking caulk job. You'll want to pull the caulk along the joint rather than push it; pulling it allows the caulk to move more smoothly over any obstructions and won't result in blobs. Your kitchen sink and bathtub or shower will have a seamless, professional-looking finish without the professional cost. You also want to practice using your caulk gun, to make sure you get a good feel for it and learn how to control the pressure. This job can be messy, so consider using a product like Caulk Mate. Again, it takes just a little practice to become a master at caulking.. The easiest way to tool the bead is to simply use your finger to wipe away any excess caulk and make sure it's worked all the way down into the seam. Once the tip is cut, load the tube into a caulking gun, and run a small test bead on some blocks of scrap wood to ensure that the opening is cut to the right size. You'll get a smooth seam, and the excess caulk will wipe right off your finger, without any mess or stickiness left behind. Hold the caulk gun at a 45 degree angle and make one smooth, quick motion with squeezing the trigger with steady pressure. Cut the nozzle close to the end, allowing for a smaller opening