Want to connect two separate steel structures together, there must be a medium in the middle, bolts are this medium, and there are many types of bolts, depending on the size of the capacity, it can be divided into ordinary bolts and high strength bolts, and Hexagon Flange Bolt is a very famous in bolts, but it is not easy to use, today Xiaobian gives you a brief introduction to the steel structural components.

1. For the hex bolts of the moving load or installed in an important part, the spring washer should be placed according to the design requirements, and the spring washer cannot be placed at will, and should be placed on the side of the nut.

2, when installing high strength hex bolts. Bolts should be able to unblocally penetrate into the gap, if the size position of the hole is not suitable, it is not forced to penetrate. If the aperture is found to be smaller than the diameter of the bolt, it is necessary to use the electric drill to drill the aperture.

3, depending on the connection, high-strength hex bolts can be roughly divided into three categories, namely friction connectivity, tensile connection, and pressurized connection. At present, most applications are frictional connections.

4, hex bolts There are their own installation sequence. When installing, it should require gradual advancement from the locations with large stiffness to unconstrained free ends. From the initial screw, twisted to the final screw should be screwed from the intermediate to tighten according to the order, and you can sit on each time it is screwed, so you can avoid a stop drainage phenomenon. The bolts of the same part should be installed within one day,

It can be seen that the installation of the steel structure Threaded Rods And Eye Bolts is not so simple, no matter what, install any bolts, should strictly abide by the installed process.