Turn on the switch and if you have done all the things properly, you must have a good or better brightness using practically half the electricity and lasting as long as 50,000 hours or more. A fluorescent tube is built into a fluorescent lighting device which consists of two or three chief components: the fluorescent lamp (fluorescent bulb or tube), the ballast, and the starter system. Also, bear in mind when maintaining a fluorescent fixture or lamp for any reason, electrical power to all the fixture should be disengaged. Depending on the particular fluorescent lighting process, the starter may be a replaceable material, a starter may not be required, or the starter function may be worked into the ballast.

Fluorescent fixtures are created to support a specific forms and dimension of fluorescent tube.

. Place the hood back on the bulb (if there was one) and start up the electricity.

Be certain that the LED replacement tube lights are the suitable size for the furnishing.

Once the ballast (and starter, if one was found) have been taken out and the wires reconnected, to accomplish an electrical connection for each bulb, change the reflector or cover over the electrical wires and the location where the ballast was located, and the LED tube lights can be inserted in the end sockets.

If the furnishing has an electronic ballast, you just need to get rid of that and wire the power straight to the lamp holders, completing one electrical connection for each bulb. You will need to make some simple corrections to the fixture to properly install the bulbs. This is simple, and usually you can use the existing wire in the fixture and then just add on some wire nuts. The starting function may also rely on the physical design of the fixture.<br />
<br />
You might need a few simple tools, such as a wire cutter and wire stripper (often built into the same tool), a couple of pliers, a screwdriver, and a few wire nuts for reconnecting any wires once you have removed the ballast. However, a large amount LED tube lights on the market today can not just be right away installed in a pre-existing fluorescent fixture. Not like fluorescent bulbs which do not have LED Low Bay Lamp a top or bottom, a LED tube light should have an apparent top and bottom, using metallic heatsink being on the backside of the tube and the LEDs noticeable under a lens on the side that will be aimed towards the area to be illuminated. Typically, it is fairly simple to remove the reflector or cover, but if it is not apparent how to accomplish enison light bulb this, you should consult the information from the bulb manufacturer. In addition, the unit for a tube lamp contains a lamp holder and a switch. The good thing is, that installing a LED tube light in a pre-existing fluorescent fixture is relatively simple. If you have an old fixture with a permanent magnetic ballast and starter, you will have to remove or open the starter and eliminate or cut the connection of the permanent magnetic ballast. To retrofit a fluorescent light bulb to support a LED tube light, the ballast (and the starter if a single one is present) must be disconnected.

Once existing bulbs are pulled from the lamp holders and the energy to the fixture is turned off, you will likely have to remove the reflector which is located behind the lights and provides a housing for the wiring and ballast that are situated right behind it.
Installing LED tube lights is a great method for saving money on electricity and bring out potentially hazardous fluorescent lights out of your home or office.