Apply all post caps to terminal posts and top rail.Seventhly, locate and set line posts. Posts should be centered in the hole. Slide a tension bar through the first row of chain-link..If there is a damaged section, trim it off by clipping off the "knuckle" with bolt cutters or with pliers and weave out the bad section.Ninthly, starting at terminal post, unroll chain link fabric on the ground, along the outside of the fence line to next terminal post. Stretch a string between each stake. is including in the opening width of the gate.Fourthly, set posts in concrete with a mixture of 1-part cement, 2-parts sand and 4-parts gravel.Fifthly, check the plumb with a carpenter's level, Gate Stoppe making sure

the chalk or crayon marks remains at ground level. After 24 hours, when the concrete footings have hardened enough for posts to stay plumb, stretch taut between terminal posts.When determining the positions of gate post, remember

clearance for hinges, latches, etc. It should be positioned on the outside face of the posts, 4" below the top. The corner posts must be higher than the standard 45 inches for the individual posts. Standard gate widths are 36 inches, 39

inches, 42 inches and 48 inches for single walk gates and 10 feet or 12 feet for double drive gates. Instructions as follows:Firstly, locate the boundary lines to your property and drive stakes into the ground along the extension of your property line.

A rule of thumb when installing chain link fencing is to not exceed 10 feet between posts.Thirdly, with crayon or chalk, mark the ground line on the posts.Be sure to consult an expert before setting the corner posts due to the different type soil and terrain.In short, as an outstanding business E-platform of promoting stone industry, we are in possession of a powerful technology group and high-efficiency operations management system.Eighthly, measure the distance between terminal posts to determine exact distance between line posts.Think you can't install a chain link limestone fence? Think again.

Fasten the tension bar/fabric combination to the evenly spaced tension bands.Eleventh, stretch the fabric.Tips & WarningsFamiliarize yourself with the fence fittings and their uses. Unwind the strand up through the links until the fabric comes apart. Set gate in place aligning top of gate with top of fence.Tenthly, add fittings to terminal post and then add rail end bands. Adjust hinges to allow for full swing.To remove excess fabric, open the top and bottom loops of a single strand of wire with pliers at the desired point of separation. Tighten all


Sixthly, when plumb, crown all concrete post footings for water drainage by sloping concrete away from post. This article will show you easy installation steps on how to do it yourself, saving you a lot of money! Your reward in the end will be a secure, nice-looking fence people will praise for years to come.Line posts should be installed so that the center of the line posts will line up with terminal post centers. Walk along the fabric, and stand it up against the the fence frame, taking out the slack as you go.

Mix a fairly heavy solution, as too much water weakens concrete, resulting in cracking.com/stonebtb. Once in place, the terminal posts should be the height of the fabric plus two inches.